News
-
Calibration Method and Daily Maintenance of Electronic Balance
No load sensitivity: gently unscrew the knob to lower the balance beam, record the zero point of the balance, and then close the knob to lift the balance beam. Use tweezers to take 10mg coil code and place it in the center of the left pan of the balance. Unscrew the knob...Read more -
The Factors that Affect the Measurement Accuracy of Electronic Truck Scale
With the acceleration of the modernization process, the number of commodities is increasing, and many commodities need to be transported and measured every year. It requires not only accurate measurement, but also rapid measurement. In that case, the dynamic electronic t...Read more -
What are the differences between truck scale and weighbridge？
In fact, the truck scale, which is commonly referred to as the weighbridge, is a large weighbridge specially used for weighing truck loads. It is a more professional statement relative to its application field, and it will be called the truck scale, mainly because the tr...Read more -
The Impact Between Temperature and the Battery of Electronic Truck Scale
Recently, it was found that the temperature dropped sharply, and the battery was full after charging, but it ran out of power after using. In this case, let's talk about the relationship between the battery and temperature: If lithium batteries are used in low temperatur...Read more -
The Repair and Maintenance of Electronic Platform Scale
After the installation of the electronic platform scale, the later maintenance is also very important. Through correct maintenance and care, the service life of the platform scale can be maximized. How to maintain the electronic platform scale? 1. Timely remove th...Read more -
Seven Common Problems and Solutions of Electronic Crane Scales
1. The electronic crane scale cannot be turned on. Before the electronic crane scale is repaired, please make sure that the electronic crane scale is not caused by the problems of the fuse, power switch, power cord and voltage switch. Check whether the electronic crane s...Read more -
The Application of Digital Load Cell During Controlling Procedure
In the industrial process control, due to the continuous operation of production, there are high requirements for the reliability of equipment, and many redundant technologies are used to ensure the reliability of measurement and control. In addition to the element balan...Read more -
How to Choose and Use the Load Cell Properly
A load cell is actually a device that converts a mass signal into a measurable electrical output. When using a load cell, the actual working environment of the load cell should be considered first, which is crucial to the correct selection of the load cell. It is related...Read more